Aquametrix SHARK TX / TXP Transmitters User Manual Manual de usuario descargar pdf (Pagina 12)

Section 3 - Electrical Connections and Setup Page 10

MULTI-PARAMETER TRANSMITTER USER’S MANUAL

Section 3 - Electrical Connections and Setup

3.6 Paddle Wheel Flow Sensor connections and setup

Figure 3.5 Connections for Flow Sensor

Once connected, step through

the LCD menus to select the

sensor in the order shown. The

Sensor K factor (pulses per U.S.

Gallon) is usually printed on the

side of the sensor or on a label

attached to the sensor cable.

The drawing shows the connnections for a typical paddle wheel flow sensor. The cable to the

sensor should not exceed 2000’ (600 meters).

Dwg# N104-45

CAUTION:

Always disconnect

the loop power

before wiring or

unwiring a sensor

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 81 82

Sin comentarios

Aquametrix SHARK TX / TXP Transmitters User Manual Manual de usuario Pagina 12